

An autonomous sweeper robot for large sites.
The LionsBot S3 is an autonomous sweeper robot that clears fine dust and larger litter in one pass. Its 780 mm cleaning width reaches right to the wall, and the S3 climbs ramps, uses lifts to move between floors and returns to base when it rains, all on its own.
The S3 advantage
Built to clean every part of the site.

The S3 clears dirt and litter in one pass.
Ramps, tight paths and wall edges: the S3 is built around the everyday conditions of a site, not just the open floor. The S3 collects fine dust, tissue, wood chips, bottles and cans, and cleans right to the wall in the same pass.
- Cleans right to the wallA 780 mm cleaning width with 0 mm edge cleaning covers corners and wall edges without a second pass.
- Handles gentle ramps and slopesClimbs slopes of up to 8°, so gentle ramps and inclines do not interrupt cleaning.
- Active dust controlHigh-flow negative-pressure ventilation traps fine particles in the bin instead of releasing them into the air.

The S3 cleans on its own.
The S3 navigates, avoids obstacles and works with other robots without supervision. The cleaning team spends less time managing the robot and more time on other work.
- AI NavSense™ and AI AdaptiveMap™AI NavSense detects people and low objects in its path and plans its own route around them. AI AdaptiveMap learns the site from one cleaning run to the next.
- Moves between floors on its ownConnects with lifts, barrier gates and automated doors already on site to complete one cleaning job across several levels.
The S3 detects litter, obstacles and rain as it cleans.

AI SpotSense™
Recognises spots where litter has gathered, in real time, and targets them, instead of only covering the floor evenly.

Avoids obstacles
AI NavSense™ detects people and low objects in its path and plans the most efficient route around them, so nobody has to intervene.

Returns to base when it rains
A waterdrop sensor detects rain and sends the S3 back to its base, so cleaning pauses safely.

Cleans its own filter automatically
The S3 cleans its dust filter automatically, so nobody has to stop the robot to clean the filter by hand.
Fleet teamwork
The S3 sweeps first. The R5 scrubs after.
The S3 works with other robots on site, so the team completes more without overlapping work or tracking every robot by hand.

S3 + S3 · Coverage without gaps
If one S3 needs to recharge or is interrupted, another on site continues the area it has not finished.

S3 + R5 · Sweep first, scrub after
The S3 clears loose dust and litter, then signals an R5 to scrub the same area, in the right order.
The S3 is built for large, busy and semi-outdoor sites.
These sites have large concrete floors, dusty parking levels, loading bays and covered areas that are partly open to the outside.
Manufacturing and warehousing
Sweeping is the first step of warehouse floor care. The S3 does that step on its own. An R5 can then scrub the same floor.
| What the floor demands | How the S3 answers |
|---|---|
| Dust and packaging waste.Pallet splinters, stretch film and cardboard dust build up, and settle on stock and scanners. | Clears dust and litter in one pass.Clears dirt and litter into a 40 L bin, with active dust control keeping particles out of the air. |
| Two passes for one floor.Dirt and litter must be removed before a scrubber can clean. | Sweep first, scrub after.The S3 signals an R5 to scrub the zone it has just swept, in the right order, without anyone sending the next robot in. |
| Proof for the audit.Food and pharmaceutical standards expect documented, verified cleaning, not paper records gathered in a rush before an audit. | Every cleaning run is reported.LionsCloud creates a report for each cleaning run, ready for the audit. |
Retail centres and large-format stores
Wholesale stores, home improvement stores and garden centres carry grit, soil and packaging that must be swept before a scrubber is used. On grocery sales floors, which are scrubbed rather than swept, the R5 is the right robot.
| What the floor demands | How the S3 answers |
|---|---|
| Concrete, indoors and under cover.Dirt and litter build up all day in store aisles, semi-covered service yards, trolley return areas and garden centres. | Indoor and semi-outdoor.Sweeps aisles and semi-covered yards and garden centres, and returns to base when its waterdrop sensor detects rain. It is not recommended for areas fully open to the weather. |
| Too few cleaners for night shifts.Early and late cleaning shifts are hard to staff, so floor care is the first task to be skipped. | Scheduled around opening hours.Cleaning runs scheduled in LionsCloud finish before the doors open, with no shift to fill. |
| Every store to one standard.Head office cannot see whether each store was cleaned on schedule. | Sweep, then scrub.The S3 clears concrete areas and the R5 scrubs the sales floor, in one fleet view for every store. |
Covered and multi-storey car parks
The S3 is built for covered, multi-storey and basement car parks, with their ramps, dust and several levels. It is made for indoor and semi-outdoor use, so it is not recommended for open-air car parks. Overnight cleaning runs raise the standard between deep cleans.
| What the floor demands | How the S3 answers |
|---|---|
| Ramps between levels.Ramps join the levels of a multi-storey or basement car park. | Handles gentle ramps.Climbs slopes of up to 8°. Steeper ramps are checked at the site survey. |
| Dust between deep cleans.Some car parks are deep cleaned only once or twice a year, and dirt builds up between them. | Cleans often, not once a year.Scheduled overnight sweeps with active dust control maintain the standard between deep cleans. |
| Several levels.Multi-storey and basement sites are linked by lifts and barriers. | Moves between levels.Lift and barrier gate integration lets one cleaning job cover several floors. |
Transport hubs
Entrance areas, cargo areas, covered car parks and bus or ferry terminals. The S3 sweeps the large concrete and semi-outdoor areas, and sweeps terminal floors first, before an R5 scrubs them.
| What the floor demands | How the S3 answers |
|---|---|
| Less time to clean at night.Passengers arrive day and night, so floor care must fit into a few quiet hours while the floor area keeps growing. | Scheduled for the quiet hours.Cleaning runs scheduled in LionsCloud start on their own. When one S3 recharges, another S3 continues its area. |
| Security checks for new staff take weeks.Background checks for secure areas mean an unfilled shift can leave a route uncleaned for weeks. | The S3 does the routine sweeping.Staff with security clearance can then do the work that needs a person. |
| Inside and outside the terminal.Entrance areas, cargo areas and walkways are partly open to the weather. | Works indoors and semi-outdoors.Built for indoor and semi-outdoor use, and its waterdrop sensor sends it back to base when rain starts. |
| Proof of service.Contracts that pay for results need proof that each area was cleaned. Paper records from a large team are hard to verify. | Every cleaning run is reported.LionsCloud creates a report for each cleaning run, ready for the contract. |
Exhibition halls and stadiums
Exhibition halls, stadium and arena concourses, loading bays and covered car parks. After an event the S3 sweeps first so an R5 can scrub immediately after. Bulky items still need manual litter collection.
| What the floor demands | How the S3 answers |
|---|---|
| Little time between events.Heavy litter after an event needs a large cleaning team before the next event is set up. | Sweeps the hall first.AI SpotSense targets litter and the S3 clears it into a 40 L bin, then signals an R5 to scrub. |
| Late-night work that is hard to staff.Clean-up starts when the event ends, late at night. | Starts when the doors close.Cleaning runs scheduled in LionsCloud begin after the last guest leaves, with no shift to fill. |
| Halls, bays and car parks on one site.A venue has several floor types on one site: concourses, loading bays and parking. | One fleet, every zone.The S3 sweeps concourses, bays and car parks, the R5 scrubs the halls, and one LionsCloud view covers both. |

One operator can manage the whole fleet.
The S3 reports to LionsCloud, LionsBot's fleet software. Schedule cleaning, monitor every S3 and R5 on site and download analytics reports from the web dashboard or the mobile app, no matter how many robots are running.
- Schedule zones once and let the fleet repeat them
- Automatic reports for every cleaning run
- One view across every S3 and R5 you operate
Scale and profitability
Estimate the hours the S3 frees up.
Enter your floor area, cleaning days and labour cost. One person can look after several robots, so each shift covers more floor without hiring more people.
- 236 eight-hour shifts
- 1 S3 unit needed
- €41,674 at your rate
Estimate only, based on calculated S3 averages. Actual results depend on your site, including its layout, floor condition, obstacles and settings.
How this is calculated, including the 15% supervision assumption
This is an estimate. LionsBot publishes the S3's maximum cleaning efficiency, up to 2,300 m² per hour, but not yet an average. The calculator uses an average of 1,400 m² per hour and about 12,000 m² per charge, worked out from the S3's published maximum and run time in the same proportion as the R5's published averages. Actual results depend on your site: its layout, floor condition, obstacles, how much litter there is and the settings used. Units needed is your daily area divided by 12,000 m² per charge, rounded up. That assumes one charge cycle per robot per day: up to 10 h of cleaning plus 2.5 h of charging. Run hours are your daily area divided by 1,400 m² per hour. The supervision share above is reserved for emptying the trash bin, spot checks and watching the robot. Only the hours left over count as freed up, spread across 52 weeks. Shifts are those hours divided by eight. The value is the same hours priced at the rate you entered, in the currency you chose, with no conversion applied. For a cost and payback analysis for your site, contact us.
Technical specifications
S3 technical specifications.
Specifications are based on internal testing and may vary by site conditions and settings. Selected features described may be released in phases.

Physical
| Dimensions (L × W × H) | 910 × 780 × 480 mm35.8 × 30.7 × 18.9 in |
|---|---|
| Weight | 80 kg176.4 lb |
| Cleaning width | 780 mm30.7 in |
| Minimum path width | 800 mm31.5 in |
| Trash bin capacity | About 40 LAbout 10.6 gal |
| Turning width | 1,200 mm47.2 in |
Cleaning performance
| Maximum slope climb | Up to 8° |
|---|---|
| Maximum cleaning speed (adjustable) | Up to 1.2 m/sUp to 2.7 mph |
| Maximum cleaning efficiency | Up to 2,300 m²/hUp to 24,757 ft²/h |
Runtime and charging
| Maximum run time | Up to 10 h |
|---|---|
| Charging time | 2.5 h |
Sound and environment
| Average sound level | Under 75 dB |
|---|---|
| Floor type | Hard floor, such as concrete and tiles |
| Usage environment | Indoor and semi-outdoor |
Navigation sensors
- 3D LiDAR
- 3 RGB cameras
- 3 depth cameras
- 2 time-of-flight sensors
Included
| Accessories | Charging station, MagicTag™, beacon light, side brushes and main brush, filter |
|---|---|
| Certifications | Company: ISO 9001, ISO 14001, ISO 45001, ISO 27001, SOC 2, SOC 3, EcoVadis, EPD. GDPR compliant. |
Designed and engineered in Singapore.
The S3 is designed and engineered in Singapore, where reliability, data integrity and sustainability are built into how we work.
LionsBot meets GDPR, SOC 2, SOC 3, ISO 9001, ISO 14001, ISO 27001 and ISO 45001. These cover data protection, privacy, quality, the environment, information security and safety. EcoVadis and EPD also recognise our environmental work.
Compare the rest of the fleet.
Autonomous cleaning robots, each engineered in Singapore and deployed globally.
S3 questions, answered.
What is the LionsBot S3?
The S3 is LionsBot's autonomous sweeper robot for large, dusty and semi-outdoor sites. It sweeps up fine dust and larger litter such as tissue, wood chips, bottles and cans in one pass, on a 780 mm cleaning width with 0 mm edge cleaning, into a 40 L trash bin.
How is the S3 different from the R5?
The S3 and the R5 do different jobs. The S3 sweeps up dust, dirt and litter over large and rougher areas. The R5 scrubs finished hard floors. On sites that need both, the S3 sweeps a zone first and then signals an R5 to scrub the same area after it.
Can the S3 work in car parks and loading areas?
Yes, in covered, multi-storey and basement car parks and loading areas. The S3 is built for indoor and semi-outdoor use, so it is not recommended for open-air car parks. It detects people and low objects in its path and goes around them, runs best when the car park is quiet, such as overnight, and climbs slopes of up to 8°.
What happens if it rains while the S3 is cleaning?
A waterdrop sensor detects rain and sends the S3 back to its base, so cleaning pauses safely instead of continuing in the rain.
Can the S3 clean more than one floor?
Yes. The S3 connects with lifts, barrier gates and automated doors already on site, so the S3 can complete one cleaning job across several levels without anyone moving it between floors.
How do I buy a LionsBot S3?
The S3 is sold through LionsBot's certified dealer network. Dealers in more than 40 countries handle sales, site survey, deployment and after-sales support. Contact us to discuss your site or to find a local dealer.
See the S3 in your operation.
Send a few details about the site and we will contact you to discuss it. No obligation.
- A look at your site, from ramps to loading bays
- Where the S3, and the R5 after it, would fit
- What the next step looks like
No site visit needed. We discuss it online.
Not ready to talk? Calculate your savings first →








